| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-26-2007, 06:49 AM
| |||
| |||
Anybody had experience with this controller? Pros and cons? Thanks  |
|
#2
07-08-2007, 11:03 PM
| |||
| |||
Have a Manford CB1050 Bed Mill with Mirl controll. System is easy to use but it regularly loses parameters.. ie will shift y zero datum when changing between program and position screens while a program is running... One time it was programmed to do 6 holes using the conversational programming. First 4 holes were fine, 5th hole the machine rapid fed into the job. Smashed drill etc.. It had "lost" the Tool length offset. the offset changed mid cycle by over 120mm.. Not too happy. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Torch Height Control / Capacitive Height Control | ahlbebuck | Open Source Controller Boards | 0 | 11-27-2006 01:32 PM |
| Fun with the new control | Michael M | AjaxCNC Control Products | 0 | 01-30-2006 11:26 PM |
| BobCADCAM Layer Control / Snap Control | jonbanquer | BobCad-Cam | 0 | 01-21-2006 03:10 PM |
| Change - from linear path control to CNC path control | fidibus42 | General Electronics Discussion | 1 | 12-04-2005 10:43 AM |
| | |
Linear Mode
