CNC Solutions in NZ & Australia

[kiwicnc]

Just letting everyone know about CNC Solutions in New Zealand. We are Camsoft dealers and specialise in retrofits and manufacture of original CNC machinery. Go to http://www.cncsolutions.co.nz for contact info.

[Carlo Rechi]

Mr kiwicnc

I have done a few retrofits for by friends in USA. Now my customers. I have studied the logic Camsoft uses and know it very good. I am still learning but like it very much. CamSoft is more powerfull then other systems I have used like Fanuc. I write to say I hope you do good down under.

Carlo

[kiwicnc]

Thanks for your reply and best wishes Carlo. You are correct about Camsoft. I went to California late last year for a few days of dealer training at Camsoft. I find the software very powerful and configurable. They were also wonderful hosts and have great after sales support.
Thanks again
Kevin

[kiwicnc]

PS Mr Moderator. I'm not sure my post is supposed to be on this forum. I tried posting on the commercial forum but it came up with 'invalid thread'. Please move post if it breaches forum conditions..