NZ: Buying complete cheap machine

[diecastblue]

I have had a hobbyCNC.com kit in my spare room for a couple of years now, and have realised that I am not going to have the time / tools to design / build my own CNC, so I am looking to get a cheap pre-made unit.

I would prefer a metal / alloy machine, but would do MDF too if it was alot better / cheaper. I was looking at "24" x 16" 3D cnc router engraving machines" sold by "cscs219" on Ebay, but there is a review thread on here saying that it is very cheaply / poorly made.

I have also found the machines at http://www.motioncam.co.nz/ (you have to click on CNC Kits), these seem to be a very reasonable price, but I haven't been able to find any reviews anywhere/. Can anyone make any comments based on the pictures of the machine?

Is there any other, pre-made units / kits, with ball screws, available in or cheaply shipped to New Zealand? I'm looking very roughly at a workable area of ~ 100cm * 50cm

Cheers.

[techtoys]

Also have a look at Craftsman CNC. I haven't used one of these, or even seen one. So I can't tell you any more than this.

Craftsman CNC welcomes you....

[cncengraver]

I have had a hobbyCNC.com kit in my spare room for a couple of years now, and have realised that I am not going to have the time / tools to design / build my own CNC, so I am looking to get a cheap pre-made unit.

I would prefer a metal / alloy machine, but would do MDF too if it was alot better / cheaper. I was looking at "24" x 16" 3D cnc router engraving machines" sold by "cscs219" on Ebay, but there is a review thread on here saying that it is very cheaply / poorly made.

I have also found the machines at http://www.motioncam.co.nz/ (you have to click on CNC Kits), these seem to be a very reasonable price, but I haven't been able to find any reviews anywhere/. Can anyone make any comments based on the pictures of the machine?

Is there any other, pre-made units / kits, with ball screws, available in or cheaply shipped to New Zealand? I'm looking very roughly at a workable area of ~ 100cm * 50cm

Cheers.

Hi

We professional manufacturer of 3D cnc router machine.

We have modle CX6090 with working area of 600*900mm. It's build with cast iron machine body with good rigidity and long service time.

It can be used to cut/engrave on wood,acrylic,metal and so on

[joe E]

Just put the money down for one of these with quick release collets to suit the Ryobi router.

ETA 20th April.

Built a small one, a few years ago, using OneCnc motors and electronics Kit.

As for the other website, did an email - no reply.