Ausee Machines & Tools
Dandenong. Mostly chinese imported stuff. All I've bought from them so far is a 20mm die wrench and the quality was better than the one that came in my set. Beyond that I can't vouch for them
Hi guys,
looking for advice on tooling suppliers for small, quality end mills 6mm and under around the Melbourne area.
I'm about done rewiring the new (mill, engraver, router, machining center) what ever it's proper name is for single phase operation -
and am about to fire it up for some testing, but I ain't got no tools, except for about 1000 carbide 3mm 60 deg chamfer bits that came with it.
these aren't going to be much help with commissioning.
Cheers
Simon
Similar Threads:
Ausee Machines & Tools
Dandenong. Mostly chinese imported stuff. All I've bought from them so far is a 20mm die wrench and the quality was better than the one that came in my set. Beyond that I can't vouch for them
Hi
I have a few metric and imperial sizes available here.
https://www.homanndesigns.com/index....ex&cPath=58_33
Peter
Sent from my iPhone using Tapatalk
-------------------------------------------------
Homann Designs - http://www.homanndesigns.com
Ali Express for cheap tools.
I use them for 316 and they are fine. I tend to use the cheap ones at a few bucks each which are what is sold here for 5x the mark up and then use expensive tools such as Sandvick and Iscar for the last passes to finish the part.
No point killing a $100 tool for roughing, when a $4 tool will do it.