Australia how to connect a touch plate to auto-zero z-axis


Results 1 to 2 of 2

Thread: how to connect a touch plate to auto-zero z-axis

  1. #1
    Registered
    Join Date
    Jan 2012
    Location
    Australia
    Posts
    12
    Downloads
    1
    Uploads
    0

    Question how to connect a touch plate to auto-zero z-axis

    Hi CNC Zone Users,

    I have a question about a TOUCH PLATE TO AUTO- ZERO Z-AXIS, I have a CNC roter that I built myself
    it was very easy to connect all drivers and servo motors to the Breakout Board because I followed the colors
    that shows the attachment that I up load, now the question Where should I connect the two black and white cables on the Breakout Board?
    I would appreciate if you make a mark for the white and the black cables on the attachment.

    Regards

    Ivan

    Similar Threads:
    Attached Thumbnails Attached Thumbnails how to connect a touch plate to auto-zero z-axis-001-jpg  


  2. #2
    Member
    Join Date
    Apr 2013
    Location
    Sweden
    Posts
    1899
    Downloads
    2
    Uploads
    0

    Default Re: how to connect a touch plate to auto-zero z-axis

    The touch plate must be connected to a free unused input of the BOB. Any input works but you have to configure it in your software as well.

    https://www.youtube.com/c/AdaptingCamera/videos
    https://adapting-camera.blogspot.com


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

how to connect a touch plate to auto-zero z-axis

how to connect a touch plate to auto-zero z-axis