Because Aspire has a fixed, limited resolution, the larger the model is, the poorer the resolution will be.
Make sure you use the highest resolution, by holding the Shift key when you start a new job, which gives you two higher resolution options.
Hello,
I import a stl file but the quality is very low. If I cut and import a piece from the stl file it gets better quality. 140 cm x 60 cm stl file on the right. 30 x 30 cm on the left. Why is this happening?
Thank you
Similar Threads:
Because Aspire has a fixed, limited resolution, the larger the model is, the poorer the resolution will be.
Make sure you use the highest resolution, by holding the Shift key when you start a new job, which gives you two higher resolution options.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I am sure "Very High (7 x Slower)" And toolpath prewiev is Maximum. It makes sense that you first said. Thank you
Very high is not the highest.
There's also:
Extremely High (20x Slower)
and
Maximum (50x Slower).
To get these, you need to hold the Shift key when you click on the "New File" icon.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)