There are a ton of tutorials on Vectrics website.
hi guys
I can't seem to get this right, I can import a bmp of wood grain and turn it into a texture but I just cant seem to get it where I need it ?
What usually happens is everything gets textured including lettering i want to leave intact and borders etc ..
Is there a turorial anywhere ?
Using aspire 8.
Thanks peeps
Similar Threads:
- Problem- How to make wave texture
- Cant get texture to completely remove
- Need Help!- texture question..
- Need Help!- texture on curve
- Share a texture
There are a ton of tutorials on Vectrics website.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
hi Gerry
Yes I have seen several vectric tutorials but .. none I have seen shows how to place the texture where you want it and how to avoid
the texture cutting over the top of letters or borders etc. i'm a little confused ATM.
This is new to me but I am used to Vinyl plotters and vectors etc.
#### Scrub that :- ) .. I just looked through the tutorials again and found what i need in the Lakeside cabin tutorial .. ### thx
Regards
Richard
Last edited by fragged; 01-15-2017 at 12:08 PM.