- Rapid pluge (Z2) info !
-
Member
Rapid pluge (Z2) info !
Not so experienced with Aspire, I'd like to find out why is it when I plot a number, say 0.25' on the Z2 plunge option, it will not carry on in my G-code ?
Say I have put in a clearance (Z1) of 1'', 2" in the 'Z' home/start position and then a 0.25'' on Z2.....it's not working ??
Thanks for any help....any advice !
Similar Threads:
-
-
Registered
Re: Rapid pluge (Z2) info !
Could you post a snippet of the code in question? Maybe which post processor you are using? I just did a simple pocket with the same z values you mentioned, and this is a snippet.
N180 G94
N190 X0.0000 Y0.0000 F60.0
N200 G00 X5.5919 Y5.0650 Z1.0000
N210 G00 Z0.2500
N220 G01 Z-0.1250
So, as far as my post processor (mach) goes, it does carry into gcode.
-
Member
- Rapid pluge (Z2) info !
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules