Simple 2D, but unable to find OFFSET?

[cjchands]

Hi guys.
I am very new to ARTCAM pro.
I want to cut simple 2D text using 1.5mm End mill.
My picture show that every time I use the
TOOLPATH (2D clearance).
I get these little offset that I didn't want.
I want to cut the pocket right where the edge of the VECTOR is.
Any tip appreciated.
THank you
Jeff

[mecanicu]

Hi guys.
I am very new to ARTCAM pro.
I want to cut simple 2D text using 1.5mm End mill.
My picture show that every time I use the
TOOLPATH (2D clearance).
I get these little offset that I didn't want.
I want to cut the pocket right where the edge of the VECTOR is.
Any tip appreciated.
THank you
Jeff

ungrup the vector's and grup only the text vector's and use 2d profiling to cut the text along vector's

[ger21]

Try pocketing the text.