- New Machine Build- Arduino 2560 + Mach3 Controller + TB6560 4 Axis 3.5A Stepper Driver Board Controller
-
Registered
Arduino 2560 + Mach3 Controller + TB6560 4 Axis 3.5A Stepper Driver Board Controller
Hello My friends,
Please i need your support ,its my new CNC machine and i need to use the following electronic system to run The machine:
Arduino 2560
TB6560 4 Axis 3.5A Stepper Driver Board Controller
Mach3 Controller
All i need the wiring diagram Between Arduino 2560 + TB6560 4 Axis 3.5A Stepper Driver Board Controller,
and confider these components in Mach3
to control (if i need ) 6 Axis via Mach3 using USB cable via Arduino 2560
i see some topics about modbus protocol,but i wish clear and easy step (step by step with supported codes if any) to do this project please
Thank you in advanced
Regards
Similar Threads:
-
- New Machine Build- Arduino 2560 + Mach3 Controller + TB6560 4 Axis 3.5A Stepper Driver Board Controller
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules