Hello My friends,

Please i need your support ,its my new CNC machine and i need to use the following electronic system to run The machine:

Arduino 2560
TB6560 4 Axis 3.5A Stepper Driver Board Controller
Mach3 Controller

All i need the wiring diagram Between Arduino 2560 + TB6560 4 Axis 3.5A Stepper Driver Board Controller,
and confider these components in Mach3

to control (if i need ) 6 Axis via Mach3 using USB cable via Arduino 2560
i see some topics about modbus protocol,but i wish clear and easy step (step by step with supported codes if any) to do this project please

Thank you in advanced

Regards

Similar Threads: