- Problem- Problems carving simple file- motor/driver issue?
-
Registered
-
-
Registered
Re: Problems carving simple file- motor/driver issue?
Looks like it's not directly connected with actual cutting but with rapid moves between cuts, it's possible that acceleration is set too high so steppers are stalling. But I assume that it's not your first try at milling so it's wise idea to think what has changed.
-
Registered
Re: Problems carving simple file- motor/driver issue?
Check your max feed rate when your code is issuing the g00 command it looks like your stalling out. Anytime G00 is issued it always uses your max feed rate.$110 |
Configuration |
x max rate, mm/min |
$111 |
Configuration |
y max rate, mm/min |
$112 |
Configuration |
z max rate, mm/min |
- Problem- Problems carving simple file- motor/driver issue?
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules