stepcraft grbl setup

[whakahere]

I have bee using my Stepcraft for a few months and all is working well. I had it paired with Estlcam but now I would like to move to Fusion 360 and use Grbl. I have done all the installing and it is operational. I am unsure how to calibrate the settings and I would like some help. This picture displays the current settings I use with Estlcam (and the only settings I know) Imgur: The most awesome images on the Internet
I am unsure how these translate to the Grbl settings

$0 = 10    (Step pulse time, microseconds)

$1 = 25    (Step idle delay, milliseconds)
$2 = 0    (Step pulse invert, mask)
$3 = 0    (Step direction invert, mask)
$4 = 0    (Invert step enable pin, boolean)
$5 = 0    (Invert limit pins, boolean)
$6 = 0    (Invert probe pin, boolean)
$10 = 1    (Status report options, mask)
$11 = 0.010    (Junction deviation, millimeters)
$12 = 0.002    (Arc tolerance, millimeters)
$13 = 0    (Report in inches, boolean)
$20 = 0    (Soft limits enable, boolean)
$21 = 0    (Hard limits enable, boolean)
$22 = 0    (Homing cycle enable, boolean)
$23 = 0    (Homing direction invert, mask)
$24 = 25.000    (Homing locate feed rate, mm/min)
$25 = 500.000    (Homing search seek rate, mm/min)
$26 = 250    (Homing switch debounce delay, milliseconds)
$27 = 1.000    (Homing switch pull-off distance, millimeters)
$30 = 1000    (Maximum spindle speed, RPM)
$31 = 0    (Minimum spindle speed, RPM)
$32 = 0    (Laser-mode enable, boolean)
$100 = 250.000    (X-axis travel resolution, step/mm)
$101 = 250.000    (Y-axis travel resolution, step/mm)
$102 = 250.000    (Z-axis travel resolution, step/mm)
$110 = 500.000    (X-axis maximum rate, mm/min)
$111 = 500.000    (Y-axis maximum rate, mm/min)
$112 = 500.000    (Z-axis maximum rate, mm/min)
$120 = 10.000    (X-axis acceleration, mm/sec^2)
$121 = 10.000    (Y-axis acceleration, mm/sec^2)
$122 = 10.000    (Z-axis acceleration, mm/sec^2)
$130 = 200.000    (X-axis maximum travel, millimeters)
$131 = 200.000    (Y-axis maximum travel, millimeters) 
$132 = 200.000    (Z-axis maximum travel, millimeters)

Similar Threads:

• Help configuring GRBL Settings in new Setup
• Need Help!- any one that knows Audrino and grbl shield with grbl pannel?....
• Need Help!- Stepcraft Choice
• X6-1500GT or Stepcraft v2 600
• Kit cnc portique Stepcraft 600

[whakahere]

I have this if it helps. The official profile of the machine.

https://www.stepcraft-systems.com/im...s-20161119.pdf