I am upgrading/updating my Probotix Fireball V90 for USB support and was wondering if anyone had use the Mega and LCD/ SD card reader instead of the UNO.

I have done the upgrade with the Uno and it was very easy to get up and running but would love to use the Mega for the ability to load files via the SD card and not be tied to the PC. If this is possible I will be doing the same upgrade/update to my FLA-100 Gecko G540 combo....

I have searched and can not find any info on the net of anyone that has done it but surely some one has.

So far I have tried Turnkey K40 Laser Arduino firmware just to see if I can get motion and get none... not sure if it is a pin out issue as I am not to good at arduino yet... Will try Marlin once I get time. I figure most of the code is out there may just have to piece it together if no one else has yet.

Similar Threads: