Ok.. I was bored...
It all works great... the buttons turn red yellow and green to indicate function and status..
The lift in the middle moves back and forth over the little green boxes and they also turn colors to indicate function and status.

I had to blur a few things out for obvious reasons.

Comments?

http://www.andersongmd.com/pickandplace/NewInterface.jpg

Looking good! I trust you also have a hardwired in E-Stop as the screen operated one does not conform to the safety code.
Al

hmmm wonder if safety codes apply to hobby cnc's? :)

I don't think it's a "hobby" machine.
http://www.cnczone.com/gallery/showgallery.php?mcats=all&si=&what=allfields&name=murphy625&when=&whenterm=&condition=and

Looking good! I trust you also have a hardwired in E-Stop as the screen operated one does not conform to the safety code.
Al


Estops are all hard wired and will cut power to the drives when activated...
I dont trust enable circutes or digital logic.

Murphy

hmmm wonder if safety codes apply to hobby cnc's? :)


Hobby what??? who??

This is no hobby machine that's for sure!! Its slightly larger than 2 semi truck trailers. That's one heck of a hobby!! LOL

Murphy