georgebarr
10-08-2009, 01:55 AM
For the IH CNC mill, where are the encoders located on each access. Are they located on the same side as the Servo motors? Or are they located on the opposite end of the Servo motors?
Thanks,
Thanks,
|
View Full Version : IH Mill encoders georgebarr 10-08-2009, 01:55 AM For the IH CNC mill, where are the encoders located on each access. Are they located on the same side as the Servo motors? Or are they located on the opposite end of the Servo motors? Thanks, Runner4404spd 10-08-2009, 10:04 AM they are located on the same side as the servo motor attached to the screw. |