janabzak
10-03-2009, 04:13 PM
im looking for post im using mastercam x4
tanks jan
tanks jan
|
View Full Version : post for mastercam x4 (vf3-ss 2009) janabzak 10-03-2009, 04:13 PM im looking for post im using mastercam x4 tanks jan littlerob 10-03-2009, 05:07 PM im looking for post im using mastercam x4 tanks jan If you are using X4 either it was recently purchased or you have paid for "maintinence" from "M.C.". So there IS a post. Click on "Machine type", click on "MILL", and scroll down to "Haas mill", and click on it, then you are done. Find your toolpath and post. But if your using VQC (a waste of time if you have paid for MasterCam), why are you concerned about a post? SlowRiderr 10-25-2009, 10:23 PM If you are using X4 either it was recently purchased or you have paid for "maintinence" from "M.C.". So there IS a post. Click on "Machine type", click on "MILL", and scroll down to "Haas mill", and click on it, then you are done. Find your toolpath and post. But if your using VQC (a waste of time if you have paid for MasterCam), why are you concerned about a post? Brother if you bought Mastercam i doubt you'd be asking this question. |