1 USED HEADSTOCK OFF A C1 MINI LATHE(SHOP FOX M1015) AND TAIL STOCK WITH MT#1 DEAD STOP THE HEADSTOCK COMES WITH ADAPTER TO MOUNT STANDARD "3 MINI LATHE CHUCK (PN-1187 YOU CAN GET FROM LITTLE MACHINE SHOP NO CHUCK INCLUDED!!!!) THE HEADSTOCK HAS MT#2 TAPER IN FRONT "3/8 BORE THRU HAS 28 TOOTH XL TIMING BELT PULLEY I ADDED TO IT EASLY REMOVED THIS WOULD BE GREAT TO MAKE 4TH AXIS OUT OF IT PRETTY SMALL HAS 4 BOLT HOLES ON FLAT BOTTOM OF HEADSTOCK ALLSO HAS KEYWAY RIGHT IN MIDDLE OF BOLT HOLES SHIPPING IN THE USA ONLY!!!!!!!!!!!!!!!!!!!!!!!!!! BIDDING STARTS AT $50. SHIPPING $9.75 FLAT RATE http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=220486189043&ssPageName=STRK

this is small enough to make a 4th axis for a taig mill but this headstock is big enough to mount the standard "3 3 jaw chuck that comes with the 7x12
mini lathe it has a adapter to mount the chuck with the headstock if you have any other questions just ask thanks

if you want to build 4th axis this is perfect for it time is allmost up

Did you sell it?

no sent you a privite message

jalessi no it did not sell sent you private message