Hi all,

Similar to mshopsteve's post I have a MV-JR stuck in the midst of an ATC tool change during power down, so the machine just boots to that error (#35).

Until I can get this figured out, can anyone help me bypass this? Can I jumper something, or are there some M-codes to reset it? I really need to get this machine running now, and can afford to go back and fix things properly at a later date. Even doing manual tool changes right now would let me get some jobs out the door, if only I could get past this alarm.

Please help if you can!

Best Regards,

Damian

Check other post For MVjr. It is not something you can bypass. Well you can, but its really not to hard to fix the problem. Try that first.