I am looking for an AlphaCAM post for a Shop Sabre (WinCNC controller). I looked a bit on this forum in the post processer thread as well as here. Anyone able to help?

Hi,
Have you contacted Planit to see if there is a generic post for this machine?

I am getting a post from Planit for CV and it should work for AC as well but I am looking for a post to compare it with what someone else is using.

I think that a post from any of the group of machines similar to the SS that are running the WinCNC controller would do the trick. Anyone have a machine like that with a 10 tool ATC?

alpha cam does not have a .tap pp or .nc

these are common gcode files that wincnc accepts?

you could look at the pp for vectric (aspire/vcarvepro) i am sure they are on the demo versions cnt, warthog, and several others are wincnc pp

jim