Im looking for a Z axis indicator, the reason is I do programs that require tool change and wondered if this could be semi automated using the indicator that K2 sell.
I would change the tool by hand and then what im hoping to do is set the machine running again, it zero's the Z axis automatically and then continues with the program.

anyone used this tool yet ?

will it even be able to do that..

Don't know the item you are talking about, but I've been looking at this site for a while: http://www.midwestrapidtool.com/

You mentioned in another thread that you'd list the problems you've had with your K2...I'm curious to know.

hindo, yes I haev had a lot of problems, without a doubt the worst thing though is the support from K2, I will be writing a "living with" kind of article about the K2 I have before too long..