I have a Kondia FV1 3Axis CNC w Delta 20 and Ac Pro Toolmaker. When I got it, I noticed the backgear lever was way pass Hi at 12 o'clock. I pulled the lever and it slipped down into the Hi mark at 9 o'clock. Now it won't go back up to 12 o'clock. It won't move.
Later on, lo and behold, I found that the M03 command does not work. Dynapath seems to think the spindle is running as there is no fault/status message. Apparently by pulling down the backgear lever like that i disengaged the spindle control and put the variable head into manual. Otherwise, the machine works fine and is in very good condition. I went around with the ohmmeter too. I highly doubt there is anything wrong mechanically or electrically.
Does anybody know how i get back spindle control?