I just replaced the presetter probe, this time myself, instead of getting a service call, and have no clue how to re-set "Setting 59 and 60" for the X values. Any Ideas ???
Haas SL 30.....

Thanks

Chris

Take a cut with a tool and set the offset manually using x offset measure.
Write down the offset.
Set the tool in X using the pre setter.
Write that number down.
Calculate the difference between the two numbers.
Add or subtract that increment to the appropriate parameter setting.
Set the tool in X again using the pre setter.
Repeat the addition/subtraction of the increments until it's within .0002/.0004 of what you calculated manually.
Remember that it won't get you closer that +/-.002 realistically, so if you've got a close tolerance back your tool off and re-size.

Repeat the process for a boring bar.