does anyone know how much Cimco DNC Maxx 4 and cimco edit is to purchase for a company? Dont need an installer just the software

Your best bet is to contact your local dealer for pricing. It changes from region to region... sometimes quite a bit too! :cheers:

Thanks'
I found out 350.00 with 1 port + 150.00 for each port after that..

Why would the software price change by region? That sounds very strange....

As a dealer for Predator Software, one price is set and resellers are bound to that price to to avoid this issue. The cost of DNC for Predator is $700 and has a killer CNC Editor included with SOLID NC Verification. Blows the pants of CIMCO :) and has way more features...

However there stuff does work....

I'm not sure why. I just know it does... not necessarily to Cimco per se, but I do know it does for some software. I've machined in 5 states and 3 countries and have seen the difference personally.

Ok, that makes more sense...CIMCO does not normally change pricing based on area since I run into them sometimes and they have quoted the same price from West Coast to East Coast.

I am sure the price is different in Europe since they can not get as much and the market it down in Europe.