The title says it all, I know how to drill with RhinoCAM but how do I get it to peck drill. Thanks.

Not sure?

In VM it is called breakchip drilling.
There is also deep hole drilling which does a full retract on each peck.
In the drilling MOP just change from "Standard Drill" in the fly-out.
Maybe

Like DareBee said, you need to choose "Peck Drill" (or something like that) from a drop menu, I think it might be in the "Cut Parameters" tab. As I just reinstalled Windows 7 I haven't got around to reinstalling Rhino and RhinoCAM yet so I can't check for you.

Found it, thanks. A little too late though, last night it broke a drill bit off in a finished piece, oh well, I've changed all the codes now.