woodman08
08-05-2009, 05:34 PM
This plate is 11x11x.75 thick was done in 5 toolpaths and 3 bit changes and had to flip the material
once .
The file came from http://www.vectorclip3d.com a company in quebec,its quite a compliment to me ,but really
i enjoyed the cut and the machine was really ramped up speed wise ,i did slow it down on the first backside cut as it was cutting a lot of wood out towards the outside of the dish.
Its wet looking because i just did it and slapped a stain on it ,should have left it raw for my salad
YouTube - 3D personalized plate
once .
The file came from http://www.vectorclip3d.com a company in quebec,its quite a compliment to me ,but really
i enjoyed the cut and the machine was really ramped up speed wise ,i did slow it down on the first backside cut as it was cutting a lot of wood out towards the outside of the dish.
Its wet looking because i just did it and slapped a stain on it ,should have left it raw for my salad
YouTube - 3D personalized plate