PDA

View Full Version : Cutting 6061 aluminum

Dropout
07-30-2009, 09:20 PM
Hi All.

What is a reasonable cutting speed on a commercial waterjet for 0.080 6061 aluminum?

Thanks.

Dropout
JakeM
08-04-2009, 11:42 AM
90ipm for a decent cut edge on the low side of pump power (30hp). Bigger pumps would be faster.
Dropout
08-04-2009, 06:01 PM
90ipm for a decent cut edge on the low side of pump power (30hp). Bigger pumps would be faster.

Thanks