I received a tool turret fault error (125) and could not move the machine any direction. I shutdown the machine and tried a auto restart as usual and I am getting a not tool home / high gear stop message. Also when it tries to home the A-axis it alarms out (alarm 106) Does anyone know what I can do to get back up and running?

does your turret unclamp correctly? Sometimes an error can be cause by low air pressure, a leak in the airline to the turret or a sticky solenoid valve. What is the explanation for the alarms you mention, just the number doesn't give much information

I just cleaned out my turret solenoid valve for the same thing. It is in the back of the machine. I just pulled mine apart, cleaned it, greased it up, and bam...works beautiful.

Be very carefull with the little rubber washers/gaskets.