I am working on setting up my new to me OKK TRC500 with the fanuc 16m control. The post I have defaults an M50 out with the G5P10000. I know the makino's use M250, M251, M252, and M253 to set the machine for different highspeed modes, the OKK is new to me and the manuals have not jumped out at me with the answer to this question. What exactly does the M50 set the machine to and are there any other M codes for highspeed on the OKK?


Danny

OKK does not provide M-codes for different high speed modes. M50 is usually the air blow. This is the external air coolant for blowing chips out of the cutting path. The G5P10000 should be on a separate line and it should be after the M50 command.

We have a OKK PG8 5axis and the code is G5P1 turns it on and G5P0 turns the high speed machining off.