I have an okk MCV560 With A Mildas 500 series control We recently lost our 4th axis drive and in the repair lost all parameters. Sence this machine came over on the mayflower we did not have a parameter list to reinstall. we have it working again but it will not take a tap command. Is there a parameter we could have missed or am I looking in the wrong direction? Tap commands worked before this last mess
Thanks
Bob

What do you mean it will not take a tap command? Do you get an alarm? If so, what number?

When you got the CNC back up in running, you had to probably re-initialize. Which mean you lost your fixed cycles. Did you load them back in. There is a special procedure to do so, but really simple. Please let me know.

Regards,

Chippy