I am trying to get a post for the Dyna 4400 mill to not output x and y values that are the same as the previous block. I have tried everything in the plin post line but I cannot get the state to change. The machine does not use standard G&M codes so it is not a normal post. The code that the mill uses is really awful but I need to get this post working so that I can reduce my file sizes. Anyone want a stab at this? Any help would be greatly appreciated as I need to cut parts as soon as I can. This post was one of the posts in the Mastercam V9 library.

Thanks,

Jim Walthall

In the plin block, you should have something like the following

pxout, pyout, pzout, pfr, e

If is like this,

pfxout, pfyout, pfzout, pfr, e

then it is being forced out. change to first sample. If you need more help

email me your post.

masspfei@yahoo.com

Thanks, Masspfei for the responce. My troubles went away on Monday when the control bit the big one. I am now in the process of a retrofit then I will be able to get back to the real world of standard G& M codes. But again thanks for the advice I will check the post and try it just to see . It is allways good to learn on posts.


Cheers

Jim Walthall

I heard your controls bit the dust. If you retorfitted it how did you take care of the ATC? I may have a chance to pick up one of the. The guy has two both in good mechanical condition. I offered to retorfit one free for him giving me the other. He said yes

Dan Mauch
Camtronics Inc
www.camtronics-cnc.com