Hello,
Does anyone know of a technician or company knowledgable in Acramatic 850 controls I could hire to get a couple of machines running?

I just purchased a Cinturn 1212 and a Cinturn 1410 they were functioning when the shop closed its doors, But it looks like they might need the program downloaded to the controller.

Thanks

Hmmm - I thought the 850 controls had flash memory that wouldn't lose their minds when the power is disconnected. I'm trying to get my hands on a couple of these lathes with the same control. I'll have to check if the controls need batteries to prevent memory loss when the power is disconnected.

Check out this site for Cinci service.
http://cinmach.mag-ias.com/

I am not positive that is what happened, the memory LED is lit on the controller. I know nothing about these controls so I was looking for someone that could help. Have you worked on acramatic 850's?
Thanks for the info

I've set-up & run machines with the 850 & 850sx controls but have no experience with trouble shooting the controls.

If you post exactly what happens when you power up the machine then someone here may be able to help. Where are you located?

Ok, I will do that when I get them all put back together and powered up.
I am in Wyoming.
Thanks

Hello,
Just got the machine all put back together and powered up.
The alarms that I get are:
EX010 Power on fail and
SB011 Graphic Ram Parity (Blue)
The control boots up and runs it checks then goes to a screen with one error that says something about a RAM error.
If I push the power on button again it goes to the normal screens (I think)
Can anyone help me out on this?
Thanks

I also have an Acramatic 850 on a Cincinnati Sabre 750, and I get a alarm on power up and diagnostics that says "comp failure 14901". There is no corresponding code in my manual, but I reset it and it usually runs okay. Now during operaton the mill shuts down with a "system fail 50" code which usually crashes the cutter and I have to restart the machine. I know that the "system fail 50" code has something to do with computer hardware/software so I believe the two codes are connected. Without the expalnation of "comp failure 14901" I don't know what to do! Can someone please help?