bobrob
04-06-2009, 10:47 AM
For both LATHE AND MILLS ?? I AM REALLY NEWW TO IT AND have version 9 And would like to know how do i have it do a canned cycle? Instead of line by line . when iam taking off a lot of stock
|
View Full Version : Newbie Master cam question ho do i set it up to do canned cycles? bobrob 04-06-2009, 10:47 AM For both LATHE AND MILLS ?? I AM REALLY NEWW TO IT AND have version 9 And would like to know how do i have it do a canned cycle? Instead of line by line . when iam taking off a lot of stock Kevin Schmidt 04-06-2009, 07:03 PM your post processor must support the canned cycles. You can edit the post to do so. bobrob 04-06-2009, 10:42 PM your post processor must support the canned cycles. You can edit the post to do so. and i will know this how ?? by clicking where ?? to find if they support it |