PDA

View Full Version : Need Help! Anilam GXM Controls



RDomeck
03-12-2009, 03:38 PM
I have an older Dal Lih knee mill W/ Anilam Crusader GXM controls and I can't get the manual motions to work. I can run a program, but it's kind of hard to locate it's position. This happened after one of the 3 phase legs blew a fuse. If I have my manual dial set for X, Z moves. Nothing happens in Y. Z moves just as it should. This machine is dated 1989. I would really like to not have to buy another machine right now. Is there anyone in the Indianapolis, In. area that you guys would suggest to come and work on it. I have a good background in electronics, I just need to be pointed in the right direction! Thanks for you help. Randy

RDomeck
03-15-2009, 05:50 PM
Anyone?