Good afternoon everybody. Can someone please tell me how to start from the point where the machine stops, due to a power failure? I'm sure everyone knows about the power issues in South Africa hahaha.

Thank you in advance!
Conrad

Good afternoon everybody. Can someone please tell me how to start from the point where the machine stops, due to a power failure? I'm sure everyone knows about the power issues in South Africa hahaha.

Thank you in advance!
Conrad

Hello,
I am not sure if this is what you mean, but when you start your machine, it asks you "go to home?" and you press the green button on the DSP. When it is home, you can press the green button again and it will travel to the XY-home of your last programm. From there you can restart your programm.
regards,
Marco

Thanks Marco, but unfortuantely that's not it. If the power goes off in the middle of a job, I would like to restart at the last line / point, not from the beginning of the job. Thanks for responding though