PDA

View Full Version : edit key offset parameter

mcash3000
03-10-2009, 05:57 PM
everytime i make an offset, whether it is a geometry or ware, i have to use the edit key.
does anyone know whcih parameter controls the edit key to make offsets on the fanuc mxp-200i control?
msa
06-28-2009, 05:49 AM
everytime i make an offset, whether it is a geometry or ware, i have to use the edit key.
does anyone know whcih parameter controls the edit key to make offsets on the fanuc mxp-200i control?

I'ts in PMC maid bi a Keeprelay or or the ladder neads to bi modiid.
dcoupar
06-28-2009, 10:54 AM
What are parameter #3290 bit 7 and #3291 bit 0 set to?