I wasn't sure where to ask but my machine (gorilla cnc) z axis bearings (4of) are difficult to get access to and they are not regular grease fittings,they look like a 3/8 x 1/4 diam brass fitting with a pin hole(facing down) ,I gather one needs a grease gun fitting that almost looks like a syringe but the tube or needle needs to be at 90 degrees.
Has camaster this type of bearing or has anyone ran accross this type of grease fitting

thanks

show us a picture of the bearing and we will see what we can do. is gorrilla unavailable to answer the question
ps: watchin you guitares is cool!!

jim

I attached a few photos of the bearings.
Gorilla manufacturing has not addressed the greasing issue(they recommended greasing every 40hrs) and i asked 3 times in the past 10 months ,i have a 2 year warranty which i realize now is an email venting warranty for me and to phone them you cannot get past the secretary or a tech person who is different each time and does not come back with solutions.
I bought canadian and close to home .well that was a laugh,I should have bought USA.This is a new industry and there are flyby night people but how do you spot them .

the bearing is listed here maybe they can help



http://www.rollco.dk/files/sysadmins/Indhold/Brochurer/PDF/Hand_clamps_2009-01.pdf

thanks will check it out amd send an email