Dear All,
First, I am new to this CNCZONE and would like to say HELLO from Israel.

Second, I have just had a disk crash on my Dart 750 (Cincinnati) with Acramatic 2100 control. I also lost my Mustang software that was inside the hard disk.
Can anyone help me with a copy of the soft?

Thanks a lot,

Joe

Do you have the Options sheet?

You will need the Applications installation diskettes (there are two).

If you have these, a copy of the software may help but the install is protracted and involved.

A new HDD from MAG with your software numbers will cost you around $700.00 USD.

This will probably be your best option.

hello Joe. i offer a similar service in the UK for £300. i would supply on a solid state drive to replace the old hard drive. there is machine information i would need. please contact me at mallard@fizz58.freeserve.co.uk if i can be of any help.
regards
mallardfizz