the post worked fine for a few days, now im getting a P for a radius when it should be a R. its an R in the prefixes files.
im also getting a D for tool offset when it used to be an H , now its a D on my G43, and there are no spaces after the line numbers like there used to be, now everything is run together except for the G43 line is the only line with a space betweeen it and the line numbers....

everything in the edit post files is correct... and this problem only started after the 3 day trial thing ran out. i have the full version and key upgrade.

yes i can add spaces but all this crap just started happening, so i have alot of extra editing.

I would check to see if the software is calling the same post you were using during the 5 day thing.

You might just want to re pick your post and try again.

Otherwise I don't know of anything I have run into that causes what you are dealing with.