chaz6966
02-21-2009, 02:01 PM
i have a 5" dia round insert turned down to 4.5" by 2" tall
the 5" is at the bottom solid by 1/2 thick
the 4.5" dia is 1.5 solid on top of that
and then there is a radiused sauser shape contour .750 deep extracted from the 4.5 diameter to make a cavity in the center.
not to complicated.
does anyone know why when i convert this file to iges or dwg/dxf. the 5" diameter disk is 374" (yes that 374 inches) (in the x minus direction) off in outer space.
the center 4.5 diameter is 100 inches deep and the extracted shape is off in y+ somewhere.
any help would be appriciated. v22 newst build
i had all three pcs diff colors for clearity.
when i changed them all to a color of gray it seemed to help. but why the problem , does color destroy data.
the 5" is at the bottom solid by 1/2 thick
the 4.5" dia is 1.5 solid on top of that
and then there is a radiused sauser shape contour .750 deep extracted from the 4.5 diameter to make a cavity in the center.
not to complicated.
does anyone know why when i convert this file to iges or dwg/dxf. the 5" diameter disk is 374" (yes that 374 inches) (in the x minus direction) off in outer space.
the center 4.5 diameter is 100 inches deep and the extracted shape is off in y+ somewhere.
any help would be appriciated. v22 newst build
i had all three pcs diff colors for clearity.
when i changed them all to a color of gray it seemed to help. but why the problem , does color destroy data.