z level finish, is there anyreason that z level finish wont cut across the floor fo a 3 d rectangular pocket with radiused corners and bottom.
description in last post.
any help would be appriciated.

Z Level will do the "Z levels" of a model. Use slice planar to get the x/y flat stuff

The Z level finish is a water line tool path. It is used to clear the vertical areas not the flats.

You could do a planner tool path like burr said, or just do a 2D pocket to finish the flats.

Then run the Z level finish to finish the vertical walls.


http://i564.photobucket.com/albums/ss86/damjuice/mkpocket.jpg

This was just a simple pocket to clear stock and finish the flat


http://i564.photobucket.com/albums/ss86/damjuice/mkzlevel.jpg

Now I did a Z level finish to finish the vertical walls.