Hi,

I have been doing some work for a local door manufacturer who has fairly recently (early last year) had a Masterwood Machining Cell installed.

I usually do service/diagnostics etc on Fanuc/Siemens/Bradley controlled equipment, but have been asked to help with a few problems on this new cell.

I am not intending to do anything major, just to be able to understand how to access and monitor I/O for switches/valves etc. and hopefully some simple analysis of some control logic.

What info do I need to get so that you to advise me, at the moment I only have the title shown at the top of an open PC control window...

MW312 V0.46 R15

Does this control system use Ladder/STL/FBD or some other type of graphical interface for the control logic?

Anyway, advice on where to start, info to get, would be appreciated

Thanks, RLMTS

Any comments on the above post anyone?