My K2 is a Great Machine, but, as seen earlier,
theres no end bearings for the Lead Screw.
Those Guide Rods are so big, they must keep the alignment.
maybe that's why K-2 didn't put them. Short Travel.
I just wanted to have something there to keep alignment for the Lead Screws
So.....

I made this Delrin Guide.
It fits in the End Plates.
And....

Here it is on my K2 Mill.
It has a close fit to the Lead Screw, so, it spinds with it.
The Outside Diameter fits into the space in the Guide Plates,so, it doesn't hinder the travel.

Here's my K2 Mill.
Clear Plexi back Panels.
Aluminum add ons..

Close-up.....

I don't know enough to give a review... :confused:
Still learning to run it...
Joey told me about K2's CNC Mill.
Thanks for tht lead to K2 Joey.
Hey Tauseef,
I got one of their Bosh Colt Router Mounts too.
Just in case I wanted to go with a Trimmer later.
The Makita 1101 is great, but, it's an overkill...
I put on a air deflector at the bottom because the Makita
blows air down thru the Body and out where the spindle and dust is.

Thanks for viewing..