Hello eveyone!
Has anyone been able to display a drawing on this controler? i have read thru
the book and found the format to use but is is not working. (dwg,<program>)
Where <program> is the program number that has the drawing in it. Any info on this would be great !!

Thanks
Tom Lafayette Ind.

I have a TNC2500 on a VMC760, also cannot display graphicly.
I believe that the post processor we are using does not correctly set a block size which causes the failure. I saw in the conversational docs a call in the first 5 lines that seems to set a block size. Our post skips that call. I have some bigger issues and haven't been able to test the theory.

Good luck, please let me know if you figure it out.

Rob