Hello.

I'm upgrade fanuc 3M (replaced 10 control chips on the motherboard). Machine now working 3-axis control simultaneous only on linear (G01 X50. Y50. Z-50 F3000) I' need to work helical (G02 G17 X50. Y50. R25 Z-10.) On display show me error no.21
I's posible change enny parameters to turn on helical cutting? :confused:

Thanks.
:withstupi

You would most likely get an answer quicker if you posted in the Fanuc section. It is just above this section, but here is a link to it. Might be faster.

http://www.cnczone.com/forums/forumdisplay.php?f=304

Parametric programming and Parameters are not the same thing.