Hello,
I am looking for a operators manuel for a yasnac 2000b control. I am rtying to hook up a btr to send a program can`t seem to get it to work. Any help would be very much appreciated .
jcyeates@sbcglobal.net
Thank you
Jason:

Give some info on your BTR. the PC you are using. The software, and the Com. cable.

It's all got to right.

JT

Try http://www.drives.com. Go downloads - browse - by controller. When you are in the page select the cnc model.

kcho,

The 2000B is not supported by Yaskawa on their site. They only go back as far as 2000G.

Also, Yaskawa could care less about BTR's. They are not and were not Factory options. So there is no support from them.

The best way to get a BTR working is either use the old Mori tech that I used. He MADE the board and gave me everything I needed to hook up the Job. Or use one of the reputable BTR manufactures in the CNC community.

JT

The hardware is the same in two cnc models. I have to put SigmaII instead the original MR DC servos and I used the 2000G Manuals.
Recomend Jason your tecnician.

Carlos