Is there someone out there that can help me how to connect three GS-D200S controllers to a printerport.
I really need some help with this (i am a newbie at this)

What's a GS-D200S controller?

Arvid

If I remember right (sometimes I do), it is a stepper controller molded into a cooling fin. Made by SGS-Thomson.

Here is a link to this in PDF format (http://www.elfa.se/pdf/54/05450333.pdf)

Looks to me like you should connect Stepclk to a STEP pin, CW/CCW to the corresponding DIR pin. Connect Enable to a SPDT switch ("växlande brytare") so you can set it high (+5V) or low (GND). According to the data sheet it should be kept low while powering up and down, and high for normal operation.

Arvid