Hey, I am having problems with the override, it doesnt respond immediately and sometimes itll jump like 2x what I told it to go if I change during an arc.

I have downloaded the hotfix for the homing problem and still having the problem with the feedrate override.
Also, sometimes it saves my tool Z height and other times it doesnt.
Do I have to save my offsets every time?

Jon

from what i'v found, you cannot change feed override during an arc. if you do, it will still register that you hit the < key, but not show up on screen until the next step. if you hit it more than once it will jump 2x or more. same deal when on a straight line, it just shows up on the screen immediately and waits til next step to change speed. interesting how v3.1 didnt have this problem. also iv made it a habit never to jog z when i hit esc during an operation, because there it will not register that z moved, and will screw up your piece.
good luck

I sent an e-mail to dakeng and he said that the feedrate over ride kicks in in the next line of code, He also said he plans on changing that back to how it was where it changes during the line.

Jon