I have a machine in the over travel position in Z
I understand I need to hold the control button in to keep the Hydraulics on but it show a button to push in the manual to press to remove power feed inhibit
I can't figure out what button I am to push so I can us the hand wheel and move the machine off the over travel

If anyone could help me with this it would be a big help

Thanks

I assume you are talking about a VMC, not sure what you mean by hydraulics. Hold the master start button then jog the axis down, also if the machine is a VMC and the tool carosel is not fully retracted it will inhibit the z axis from moving down.

Rick

Is it not the data set button?

NO IT IS NOT THE DATA SET BUTTON IT IS THE MACHINE POWER ENABLE GREEN BUTTON THE ONE THAT YOU TURN YOUR CONTROL ON WITH WHEN YOU POWER IT UP. THEN USE THE -Z AXIS JOG BUTTON NOT THE HANDWHEEL.