Ok, I have been using Lazy Cam for about a year and have become pretty comfortable with it.

I'm having an issue where the z axis goes to the rapid height after making a pass in a multi pass program. This sometimes takes as much time to do than the cut. How do I turn this off?

It would be ideal for the program to "spiral" down when making a round hole.

As of now, I need to manually edit out each line in g-code to get it to do what I want.

Does that make sense?

Sonicmook56,
Had any luck with killing the rapid height move each pass? I have the same challenge but have not figured out how to eliminate it either. foamcutter